Light Bulbs

Light Bulbs


image

Headlights (High/Low beam)

image

/Daytime running lights Parking lights

Front turn signal lights

/Parking lights

Overhead lights

/Front map lights Ambient lights


Vanity mirror lights Side turn signal lights

Front side-marker lights


image

Daytime running lights

/Parking lights


image

High-mount brake light Rear map lights


Rear turn signal lights



Luggage compartment light


image

License plate lights Reverse lights


Rear side-marker lights Brake lights/Taillights

Taillights

Some models.


image

CAUTION

CAUTION

CAUTION

When removing the lens or lamp unit using a flathead screwdriver, make sure that the flathead screwdriver does not contact the interior terminal. If the flathead screwdriver contacts the terminal, a short circuit may occur.


NOTE

- To replace the bulb, contact an Authorized Mazda Dealer.


- Use the protective cover and carton for the replacement bulb to dispose of the old bulb promptly and out of the reach of children.

image

Replacing Exterior Light Bulbs

All the exterior light bulbs are LED type. The LED bulb cannot be replaced as a single unit because it is an integrated unit. The LED bulb has to be replaced with the unit. If a replacement is necessary, consult an Authorized Mazda Dealer.

Replacing Interior Light Bulbs

The interior lights have either LEDs or normal bulbs.

LED type

- Overhead lights/Front map lights

- Rear map lights

- Vanity mirror lights*

- Luggage compartment light

- Ambient lights*

The LED bulb cannot be replaced as a single unit because it is an integrated unit. The LED bulb has to be replaced with the unit. If a replacement is necessary, consult an Authorized Mazda Dealer.

Bulb type

Overhead light/Front map lights, Rear map lights, Vanity mirror lights*

1. Wrap a flathead screwdriver with a soft cloth to prevent damage to the lens, and then remove the lens by carefully prying on the edge of the lens with a flathead screwdriver.

2. Disconnect the bulb by pulling it out.

Overhead light/Front map lights

image


image image


Rear map lights

image


image

Vanity mirror lights*

image

image

image

Driver’s seat


image

image

image

Passenger’s seat

3. Install the new bulb in the reverse order of the removal procedure.

Luggage compartment light

1. Wrap a small flathead screwdriver with a soft cloth to prevent damage to the lens and remove the lens unit by carefully prying on the edge of the lens unit with the flathead screwdriver.

image


2. Disconnect the electrical connector from the bulb by pressing the tab on

*Some models. 6-41


the connector with your finger and pulling the connector.

image


image

CAUTION

CAUTION

CAUTION

When replacing the bulb always disconnect the connector first. Otherwise, electric and electronic devices could be shorted.

3. Insert the flathead screwdriver into the gap between the lens and the lens unit, and then slide the screwdriver to detach the lens.


4. Disconnect the bulb by pulling it out.

image

5. Install the new bulb in the reverse order of the removal procedure.


image

image


image

Tires

(Page 183)

Tires ‌WARNINGWARNINGWARNINGFor reasons of proper performance, safety, and better fuel economy, always maintain recommended tire inf...

Fuses

(Page 185)

Fuses ‌Your vehicle's electrical system is protected by fuses.If any lights, accessories, or controls do not work, inspect the a

We also have owner's manuals for other vehicle years:

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car Mazda CX-5 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!