Key Battery Replacement

Key Battery Replacement

If the buttons on the transmitter are inoperable and the operation indicator light does not flash, the battery may be dead.

image

CAUTION

Replace with a new battery before the transmitter becomes unusable.


- Make sure the battery is installed correctly. Battery leakage could occur if it is not installed correctly.

- When replacing the battery, be careful not to touch any of the internal circuitry and electrical terminals, bend the electrical terminals, or get dirt in the transmitter as the transmitter could be damaged.

- There is the danger of explosion if the battery is not correctly replaced.

- Dispose of used batteries according to the following instructions.

- Insulate the plus and minus terminals of the battery using cellophane or equivalent tape.

- Never disassemble.

- Never throw the battery into fire or water.

- Never deform or crush.

- Replace only with the same type battery.

(Type A)

Use CR2025 or an equivalent.

(Type B)

Use CR2032 or an equivalent.

The following conditions indicate that the battery power is low:

- The KEY indicator light (green) flashes in the instrument cluster for about 30

seconds after the engine is switched OFF (for vehicles with a type A/type B instrument cluster (page 4-13, 4-30), messages are displayed in the instrument cluster).

- The system does not operate and the operation indicator light on the transmitter does not flash when the buttons are pressed.

- The system's operational range is reduced.

Replacing the battery at an Authorized Mazda Dealer, is recommended to prevent damage to the key. If replacing the battery by yourself, follow the instruction.

Replacing the key battery Type A

1. Press the knob and pull out the auxiliary key.

image

Knob

image


image

Cover

Cover

Cover

2. Twist a tape-wrapped flathead screwdriver in the direction of the arrow and open the cover slightly.

image

Cover

Cover

Cover

Gap

Gap

Gap

3. Insert the tape-wrapped flathead screwdriver into the gap and slide it in the direction of the arrow.

4. Twist the flathead screwdriver in the direction of the arrow and remove the cover.

5. Remove the battery cap, then remove the battery.

image


image


image

CAUTION

- Be careful not to allow the rubber ring shown in the figure to be scratched or damaged.

- If the rubber ring detaches, reattach it before inserting a new battery.

Rubber ring

image

image

Cover

image


6. Insert a new battery with the positive pole facing up, and then cover the battery with the battery cap.

image

7. Close the cover.

image

8. Reinsert the auxiliary key.

Type B

1. Remove the lower cover while pressing the knob in the direction of the arrow.

2. Press in the tab to unlock the upper cover.

image

3. Insert a tape-wrapped flathead screwdriver into the gap and slide it in the direction of the arrow.

image

image

4. Twist the flathead screwdriver in the direction of the arrow and remove the upper cover.


image

image


5. Remove the cap using the

tape-wrapped flathead screwdriver.

image

6. Remove the battery using

tape-wrapped flathead screwdriver.

image

7. Insert a new battery into the transmitter so that the positive pole is facing up.

8. Install the cap.

9. Install the upper cover.

image

10. Insert the tabs of the lower cover into the slots of the transmitter and install the lower cover.

image


image

image


Battery

(Page 200)

Battery WARNINGWARNINGWARNINGWash hands after handling the battery and related accessories:Battery posts, terminals a...

Tires

(Page 202)

Tires WARNINGWARNINGWARNINGFor reasons of proper performance, safety, and better fuel economy, always maintain recommended tire inflation

We also have owner's manuals for other vehicle years:

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car Mazda CX-5 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!