Keyless Entry System

A code number is stamped on the plate attached to the key set; detach this plate and store it in a safe place (not in the vehicle) for use if you need to make a replacement key (auxiliary key).‌

Also write down the code number and keep it in a separate safe and convenient place, but not in the vehicle.


If your key (auxiliary key) is lost, consult your Authorized Mazda Dealer and have your code number ready.

NOTE

The driver must carry the key to ensure the system functions properly.


Transmitter

image

Operation indicator light Auxiliary key


imageKey code number plate


image

Pull out the auxiliary key from the key (transmitter).

Keyless Entry System

This system uses the key buttons to remotely lock and unlock the doors and the liftgate.

The system can start the engine without having to take the key out of your purse or pocket.

It can also help you signal for attention. Operating the theft-deterrent system is also possible on theft-deterrent system- equipped vehicles.

Press the buttons slowly and carefully.


System malfunctions or WARNINGs are indicated by the following WARNING lights or beeps.

For vehicles with the type A instrument cluster, check the displayed message for more information and, if necessary, have the vehicle inspected at an Authorized Mazda Dealer, according to the indication.

KEY WARNING Light (Red)

Refer to WARNING/Indicator Lights on page 4-22.

Ignition Not Switched Off (STOP) WARNING Beep

Refer to Ignition Not Switched Off (STOP) WARNING Beep on page 7-33.

Key Removed from Vehicle WARNING Beep

Refer to Key Removed from Vehicle WARNING Beep on page 7-34.

If you have a problem with the key, consult an Authorized Mazda Dealer.


If your key is lost or stolen, consult an Authorized Mazda Dealer as soon as possible for a replacement and to make the lost or stolen key inoperative.

image



image

CAUTION

CAUTION

CAUTION

Radio equipment like this is governed by laws.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE

The keyless entry system operation may vary due to local conditions.

The keyless entry system is fully operational (door/liftgate lock/unlock) when the push button start is switched off. The system does not operate if the push button start is switched to any position other than off.

If the key does not operate when pressing a button or the operational range becomes too small, the battery may be dead. To install a new battery, refer to Replace Electrical Battery(page 6-33).

Additional keys can be obtained at an Authorized Mazda Dealer. Up to 6 keys can be used with the keyless functions per vehicle. Bring all keys to an Authorized Mazda Dealer when additional keys are required.

Transmitter

NOTE

(With theft-deterrent system)

The hazard WARNING lights flash when the theft-deterrent system is armed or turned off.

Refer to Theft-Deterrent System on page 3-37.

(With the advanced keyless function)

A beep sound can be heard for confirmation when the doors and liftgate are locked/ unlocked using the key. If you prefer, the beep sound can be turned off.

The volume of the beep sound can also be changed.

Refer to Personalization Features on page 9-10.

Use the following procedure to change the setting.

1. Switch the ignition off and close all of the doors and the liftgate.

2. Open the driver's door.

3. Within 30 seconds of opening the driver's door, press and hold the LOCK button on the key for 5 seconds or longer.

All of the doors and the liftgate lock and the beep sound activates at the currently set volume. (If the beep sound is currently set to not activate, it will not activate.) The setting changes each time the LOCK button on the key is pressed and the beep sound activates at the set volume. (If the beep sound has been set to not activate, it will not activate.)

4. The setting change is completed by doing any one of the following:

Switch the ignition to ACC or ON.

Close the driver's door.

Open the liftgate.

The key is not operated for 10 seconds.

Press any button except the LOCK button on the key.

A request switch is pressed.

image


The operation indicator light flashes when the buttons are pressed.

Lock button

To lock the doors and the liftgate, press the lock button and the hazard WARNING lights will flash once.

(With the advanced keyless function)

A beep sound will be heard once.


To confirm that all doors and the liftgate have been locked, press the lock button again within 5 seconds. If they are closed and locked, the horn will sound.


image


NOTE

The doors and the liftgate can be locked by pressing the lock button while any other door or the liftgate is open. The hazard WARNING lights will not flash.

When the lock button is pressed while any door is open and then the door is closed, all the doors and the liftgate are locked.

Confirm that all doors and the liftgate are locked visually or audibly by use of the double click.

Make sure all doors and the liftgate are locked after pressing the button.

(With theft-deterrent system)

When the doors are locked by pressing the lock button on the key while the theft- deterrent system is armed, the hazard WARNING lights will flash once to indicate that the system is armed.

Unlock button

To unlock the driver's door, press the unlock button and the hazard WARNING lights will flash twice.

(With the advanced keyless function)

A beep sound will be heard twice.


To unlock all doors and the liftgate, press the unlock button again within 3 seconds and two more beep sounds will be heard.


image


NOTE

The system can be set to unlock all doors by performing a single operation.

Refer to Personalization Features on page 9-10.

Use the following procedure to change the setting.

1. Switch the ignition off and close all of the doors and the liftgate.

2. Open the driver's door.

3. Within 30 seconds of opening the driver's door, press and hold the UNLOCK button on the key for 5 seconds or longer. The sound of the doors locking/unlocking can be heard.

After this, the system switches the setting each time the UNLOCK button is pressed (the sound of the doors locking/unlocking can be heard).

image


4. The setting change is completed by doing any one of the following:

Switch the ignition to ACC or ON.

Close the driver's door.

Open the liftgate.

The key is not operated for 10 seconds.

Press any button except the UNLOCK button on the key.

A request switch is pressed.

(Auto re-lock function)

After unlocking with the key, all doors and the liftgate will automatically lock if any of the following operations are not performed within about 60 seconds. If your vehicle has a theft-deterrent system, the hazard WARNING lights will flash for confirmation. The time required for the doors to lock automatically can be changed.

Refer to Personalization Features on page 9-10.

A door or the liftgate is opened.

The push button start is switched to any position other than off.

(With theft-deterrent system)

When the doors are unlocked by pressing the unlock button on the key while the theft- deterrent system is turned off, the hazard WARNING lights will flash twice to indicate that the system is turned off.

Panic button

If you witness from a distance someone attempting to break into or damage your vehicle, press and hold the panic button to activate the vehicle's alarm.

NOTE

The panic button will work whether any door or the liftgate is open or closed.

(Turning on the alarm)

Pressing the panic button for 1 second or more will trigger the alarm for about 2 minutes and 30 seconds, and the following will occur:

The horn sounds intermittently.

The hazard WARNING lights flash.

(Turning off the alarm)

The alarm stops by pressing any button on the key.


Operational Range

The system operates only when the driver is in the vehicle or within operational range while the key is being carried.

Starting the Engine

NOTE

Starting the engine may be possible even if the key is outside of the vehicle and extremely close to a door and window, however, always start the engine from the driver's seat.

If the vehicle is started and the key is not in the vehicle, the vehicle will not restart after it is shut off and the push button start is switched to off.

The luggage compartment is out of the assured operational range, however, if the key (transmitter) is operable the engine will start.

image image image image

image


With the advanced keyless function


Interior antenna

image


image Operational range


Without the advanced keyless function


Interior antenna

image


image Operational range


NOTE

The engine may not start if the key is placed in the following areas:

Around the dashboard

In the storage compartments such as the glove compartment


Key Suspend Function

If a key is left in the vehicle, the functions of the key left in the vehicle are temporarily suspended to prevent theft of the vehicle.

The following are inoperable:

Starting the engine using the push button start.

(With the advanced keyless function)

Operating the request switches.


To restore these functions, perform any one of the following:

Press a button on the key which has had its functions temporarily suspended.

(Manual transaxle)

When carrying another key, depress the clutch pedal until the KEY indicator light (green) illuminates.

(Automatic transaxle)

When carrying another key, depress the brake pedal until the KEY indicator light (green) illuminates.

Refer to WARNING/Indicator Lights on page 4-22.

image

Keys

(Page 41)

Keys ‌Do not leave the key in your vehicle with children and keep them in a place where your children will not find or play with t...

Advanced Keyless Entry System

(Page 43)

Advanced Keyless Entry System‌Advanced Keyless Entry SystemíAdvanced Keyless Entry SystemíAdvanced Keyless Entry SystemíWARNINGWARNINGWARNINGRadi

We also have owner's manuals for other vehicle years:

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car Mazda CX-5 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!